HP HP2-Z32 dumps - 100% Pass Guarantee!

Which feature differentiates the default VSC from other VSCs that are configured on an MSM Controller?

A. Traffic from the default VSC is always routed out the Internet port.

B. The default VSC can be used to control untagged wired traffic that is received on the LAN port.

C. The default VSC must always be access controlled.

D. Wireless clients that fail authentication to another VSC are assigned to this VSC.

When does 802.1X authentication of a wireless station occur?

A. It occurs after the 802.11 association process, but before the 802.11 authentication process.

B. It occurs after the 802.11 association process.

C. It occurs in place of the 802.11 authentication process.

D. It occurs after the 802.11 authentication process, but before the 802.11 association process.

A network administrator is designing wireless meshing for an HP MSM AP. What is a correct guideline that the network administrator should follow?

A. Do not configure a wireless mesh on an AP that supports 802.11n clients

B. Create at least eight links on one radio before establishing a link on a second radio.

C. Enable 802.1X authentication on the mesh link.

D. Dedicate a radio to the mesh link whenever possible

Users report that the 802.11n wireless network is extremely slow. The network administrator suspects that the problem is occurring because of a hidden node.

Which mechanism is a solution for this problem?

A. Short Guard Interval (SGI)

B. Reduced Inter-Frame Spacing (RIFS)

C. CTS-to-Self

D. Carrier sense multiple access with collision avoidance (CSMA/CA)

Refer to the exhibit.

Portion of the settings for VSC profile A VSC profile B and VSC profile C. A network administrator is deploying an HP MSM solution for a hotel. The solution consists of an HP MSM760 Access Controller, 50 HP MSM317 Access Devices, and several HP SMS460 Aps. The hotel plans to connect voice over IP (VoIP) phones to port 1 on each HP MSM317. To protect the ports from unauthorized access, the network administrator will configure the ports to support MAC authentication to accounts configured on the controller. The exhibit shows a portion of the settings for three VSCs Each VSC is enabled for MAC authentication.

How can the network administrator configure port 1 on the MSM317s to meet this requirement?

A. Configure switch port 1 at the controlled Aps level and bind VSC A to it.

B. Configure switch port 1 at the controlled Aps level and bind VSC B to it.

C. Configure switch port 1 at the controlled Aps level and bind VSC C to it.

D. Configure switch port 1 at the controlled Aps level and enable MAC authentication on it.