Nutanix NCS-CORE dumps - 100% Pass Guarantee!

A customer has a G6 AHV cluster with 4x10GbE NICs on each node and the following configuration:

*

Networking is set to default

*

Only two NICs are connected

The customer receives the following critical message:

The NIC is disconnected from the switch, or the switchport is failing.

What should the consultant verify to resolve the issue?

A. The NICs are configured for active-backup.

B. The VLANs are configured correctly on the switch or tagged on the cluster.

C. The other two 10GbE connections are removed from the default bond.

D. The NICs are connected for balance-slb.

An administrator receives reports that VDI desktop performance in an 8-nodeNutanix VDI environment is poor. Opening applications takes between 1 and 2 minutes.

When investigating the issue, the following conditions are found:

Cluster memory utilization: 80% Cluster SSD utilization: 70% Average VM CPU Wait Time: 11% CVM CPU utilization: 75%

Which action should be taken to improve VDI performance?

A. Increase the amount of SSD storage in the cluster.

B. Add memory to the nodes in the cluster.

C. Add CPU resources to the cluster.

D. Increase the number of vCPU cores allocated to the CVM.

A Nutanix cluster has 10TB usable storage. The customer wants to create a 100GB datastore for ISO images to eliminate too much storage being consumed by unnecessary images. Which setting should be used to accomplish this goal?

A. From Container Advanced Settings, configure 100GB for advertised capacity.

B. From Container Advanced Settings, enable erasure coding.

C. From Container Advanced Settings, turn on compression and deduplication.

D. From Container Advanced Settings, configure 100GB for reserved capacity.

An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to theCVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss. The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

A. Replace the cable from eth2 to the switch

B. Remove eth3 from br0-up and monitor for new alerts

C. Check the port on the switch side for any errors

D. Enable balance-s1b on br0-up and monitor if a problem persists

Refer to the exhibits.

An administrator has reported that a new VM is not performing well.

After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?

A. VM is CPU constrained since the hypervisor cannot provide the required resources.

B. VM is CPU constrained because more CPU needs to be added to the VM.

C. VM is Storage constrained, because the workload is waiting for storage access.

D. VM is not CPU constrained, because the VM is not running, a multithreaded application.