Fortinet NSE7_EFW-7.0 dumps - 100% Pass Guarantee!

Examine the IPsec configuration shown in the exhibit; then answer the question below.

An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands: diagnose vpn ike log-filter src-addr4 10.0.10.1 diagnose debug application ike -1 diagnose debug enable The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output. Why isn't there any output?

A. The IKE real time shows the phases 1 and 2 negotiations only. It does not show any more output once the tunnel is up.

B. The log-filter setting is set incorrectly. The VPN's traffic does not match this filter.

C. The IKE real time debug shows the phase 1 negotiation only. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1.

D. The IKE real time debug shows error messages only. If it does not provide any output, it indicates that the tunnel is operating normally.

Examine the output of the `diagnose ips anomaly list' command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

A. Those whose traffic matches a DoS policy.

B. Those whose traffic matches an IPS sensor.

C. Those whose traffic exceeded a threshold of a matching DoS policy.

D. Those whose traffic was detected as an anomaly by an IPS sensor.

Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

A. In the network connected to port 4, two OSPF routers are down.

B. Based on the network type of port 4, OSPF hello packets will be sent to 224.0.0.5.

C. Based on the network type of port 4, OSPF hello packets will be sent to 224.0.0.6.

D. There are a total of 5 OSPF routers attached to the Port4 network segment.

Refer to the exhibit, which contains partial output from an IKE real-time debug.

Why did the tunnel not come up?

A. The local gateway has configured less secure encryption and hashing algorithms compared to the remote gateway.

B. The Diffie-Hellman group does not match on the local and remote gateways.

C. The proposal ID does not match between local and remote gateways.

D. The encapsulation method for phase 2 is set to none on local and remote gateways.

Which two statements about bulk configuration changes made using FortiManager CLI scripts are correct? (Choose two.)

A. When run on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate device.

B. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.

C. When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.

D. When run on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate device.