NSE6_FWF-6.4 Online Practice Questions and Answers

Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

A. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

B. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

C. DARRP measurements can be scheduled to occur at specific times.

D. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

Part of the location service registration process is to link FortiAPs in FortiPresence.

Which two management services can configure the discovered AP registration information from the FortiPresence cloud? (Choose two.)

A. AP Manager

B. FortiAP Cloud

C. FortiSwitch

D. FortiGate

Which two configurations are compatible for Wireless Single Sign-On (WSSO)? (Choose two.)

A. A VAP configured for captive portal authentication

B. A VAP configured for WPA2 or 3 Enterprise

C. A VAP configured to authenticate locally on FortiGate

D. A VAP configured to authenticate using a radius server

Which administrative access method must be enabled on a FortiGate interface to allow APs to connect and function?

A. Security Fabric

B. SSH

C. HTTPS

D. FortiTelemetry

Refer to the exhibit.

What does the asterisk (*) symbol beside the channel mean?

A. Indicates channels that can be used only when Radio Resource Provisioning is enabled

B. Indicates channels that cannot be used because of regulatory channel restrictions

C. Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)

D. Indicates channels that are subject to dynamic frequency selection (DFS) regulations

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

A. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility

B. Areas with the signal strength weaker than -68 dB are cut out of the map

C. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor

D. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.

A tunnel mode wireless network is configured on a FortiGate wireless controller. Which task must be completed before the wireless network can be used?

A. The wireless network interface must be assigned a Layer 3 address

B. Security Fabric and HTTPS must be enabled on the wireless network interface

C. The wireless network to Internet firewall policy must be configured

D. The new network must be manually assigned to a FortiAP profile

What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?

A. DHCP

B. Static

C. Broadcast

D. Multicast