EMC E20-329 dumps - 100% Pass Guarantee!

A customer is planning a new database rollout using Oracle and wants to perform online backups. Initial tests with NetWorker have shown that the backups cannot be completed within the backup window of 6 hours.

You have analyzed your backup environment and there are adequate resources to meet this stringent backup window. What is one of the first things to check in NetWorker or RMAN to increase performance without adding cost and complexity?

A. Adjust the maximum number of files in a backup set to be less than the number of open files

B. Adjust RMAN channels to have multiple streams per tape device

C. Adjust RMAN multiplexing to be less than the tape multiplexing setting

D. Adjust RMAN multiplexing to be equal to or greater than the tape multiplexing setting

A Symantec Backup Exec customer purchased an EMC Disk Library (EDL) last year and performs 1.5 TB of nightly backups. Backup Exec is used to copy EDL virtual tapes to physical tapes to satisfy offsite requirements. The daily backup and tape copying workload is becoming a challenge for their Backup Exec server.

The customer is exploring EDL-to-EDL replication to a second a second site seven miles always to eliminate physical tape and reduce the Backup Exec server workload. Which EDL relocation option meets the customer's requirements?

A. Remote Copy over an IP connection

B. Consolidated Media Management over extended Fibre Channel

C. Tape Caching over extended Fibre Channel

D. Auto Archive over an IP connection

A long-term EMC SRDF customer wants to make their backups tapeless. The customer has asked for your recommendation on the bandwidth required for replication of 10 TB of daily backup data that is currently going to tape nightly. Bandwidth is provided by two OC-3 circuits between the source and target data center locations.

Which information is needed to architect a solution for the customer?

A. Available bandwidth, latency, and throughput objective

B. Total bandwidth, trace route, and hops

C. Circuit distance, line condition, and transmission rate

D. Total bandwidth, latency, and compression rate

While designing an EMC Data Domain solution, you need to determine the required amount of storage capacity. The following information was gathered from the customer:

2 TB full backup @ 5x compression 10% daily data change rate 4 incremental/week @ 10x compression 1x full per week @ 25x compression Retention period = 4 weeks with no data growth

What is the minimum amount of storage needed to support this solution?

A. 850 GB

B. 900 GB

C. 1040 GB

D. 1200 GB

An EMC NetWorker customer wants to use Data Domain Boost to take advantage of less LAN traffic traversing the network. However, after performing a backup, the LAN administrator noticed that the same amount of data is being transmitted from the storage node to the Data Domain as it is from the client to the storage node.

What needs to be enabled to take advantage of DD Boost on the storage node?

A. Distributed Segment Processing on the Data Domain

B. Distributed Segment Processing on the storage node

C. DD Boost on the storage node

D. DD Boost license on the NetWorker server