Certbus > HP > HP ExpertONE Certification > HP2-T23 > HP2-T23 Online Practice Questions and Answers

HP2-T23 Online Practice Questions and Answers

Questions 4

Which Virtual Connect module enables FCoE or iSCSI connectivity for BladeSystem server blades?

A. VC1/10Gb-F

B. VC-FC8/24

C. VC FIexFabric

D. VCFIex-10

Browse 109 Q&As
Questions 5

Microsoft Windows BitLocker Encryption feature uses a TPM microcontroller chip to store certificates and encryption keys on a DL380 G7.

Which action must a field engineer perform before upgrading server firmware and installing an additional storage controller?

A. Create new certificates and encryption keys.

B. Disable BitLocker.

C. Delete certificates and encryption keys.

D. Disable TPM.

Browse 109 Q&As
Questions 6

What are the upgrade options for HP FlexLOM? (Select two.)

A. 100 MM

B. 1 Gb/s

C. 10 Gb/s

D. 100 Gb/s

Browse 109 Q&As
Questions 7

How do you boot into Intelligent Provisioning on a ProLiant Gen8 server?

A. by pressing the F9 button during POST

B. pressing the F10 button during POST

C. through a Scripting Toolkit server configuration script

D. through the Array Configuration Utility (ACU) in offline mode

Browse 109 Q&As
Questions 8

From which location does Active Health collect data?

A. iLO

B. SMH

C. Event Log

D. IML

Browse 109 Q&As
Questions 9

Which statements are correct about HP Systems Insight Manager (HP SIM) 7.0 Agentless Management? (Select two.)

A. HP SIM communicates with the CPU and collects essential data for the operating system.

B. Agentless Management is provided by the CPU.

C. HP SIM communicates with the iLO Management Engine to collect hardware data.

D. The Agentless Management Service runs on the host to provide software information directly to the iLO Management Engine.

Browse 109 Q&As
Questions 10

What are features of Option ROM Configuration for Arrays (ORCA)? (Select two.)

A. Smart Array Advanced Pack license registration

B. Online spare assignment

C. Drive expansion

D. Ability to set the stripe size

E. RAID level migration

Browse 109 Q&As
Questions 11

What is needed to support Dynamic Power Capping at the enclosure level?

A. Insight Control power management software

B. Redundant Onboard Administrator modules

C. Redundant power supplies

D. Intelligent PDU (iPDU) and intelligent extension bars

Browse 109 Q&As
Questions 12

What should be run in the Virtual Connect Support Utility (VCSU) before initiating a Virtual Connect firmware upgrade?

A. Show all

B. VC Support Dump

C. Health Check

D. Show Config

Browse 109 Q&As
Questions 13

A ProLiant DL380 Gen8 ser/er has become unresponsive several times during the last two weeks You contacted HP Technical Support and were asked to send them the Active Health System log for the last two weeks Where can you download this log? [Select two.)

A. Array Configuration Utility (ACU)

B. iLO infoimatioi page

C. Integrated Management log (IML)

D. Intelligent Provisioning Maintenance page

E. ROM Based Setup Utility (RBSU)

Browse 109 Q&As
Questions 14

You cannot get to the network from any of the server blades in a c7000 enclosure with 10GbE Pass-Thru modules.

What should you verify first for proper connectivity to the network?

A. Correct SFPs are installed

B. External switch supports at least Gigabit speed

C. Interconnect link between the Pass-Thru modules

D. External switch set to half duplex

Browse 109 Q&As
Questions 15

Which RAID level allows the data to be striped across multiple RAIDs? (Select two.)

A. RAID 0

B. RAID 1

C. RAID 5

D. RAID 50

E. RAID 60

Browse 109 Q&As
Questions 16

A support engineer is troubleshooting a ProLiant DL360p Gen8 server.A hard disk m a four drive RAID 5 set has failed.The engineer notices that on three of the drives, the LEO labeled D on the exhibit is on.What does the condition indicate?

A. Hot swapping of the failed drive is not supported in this condition

B. The LED indicates failure and predictive failure alerts. Two additional drives in the RAID set are at risk of failing and need to be replaced

C. The drives should not be removed when this LED is illuminated

D. The drive failure has corrupted three drives in the RAID set. The array must be rebuilt and data restored from backup

Browse 109 Q&As
Questions 17

What should be installed on a ProLiant Gen8 server to display operating system information within the iLO 4 GUI?

A. System Management Home Page

B. HP Management Agents

C. Agentless Management Service

D. ProLiant Support Pack

Browse 109 Q&As
Questions 18

Which tools should you use to identify correctable memory errors on a ProLiant Gen8 server that has an operating system without HP management agents installed? (Select two)

A. iLO

B. System Management Home page

C. Active Health System

D. ACU

E. ROM

Browse 109 Q&As
Exam Code: HP2-T23
Exam Name: Supporting Industry Standard Server Solutions
Last Update: Mar 19, 2025
Questions: 109 Q&As

PDF

$49.99

VCE

$55.99

PDF + VCE

$65.99