What CLI command is used to show the port membership of only VLAN default?
Given the following information, select the option that would allow you to change the active ExtremeWare version to 6.1.9b11 upon reboot.
A. use image primary
B. download config primary
C. use config primary
D. download image primary
Which CLI command will remove the IP address that has been assigned to the default VLAN?
A. config default unconfig ipaddress
B. config default delete ipaddress
C. unconfig default ipaddress
D. disable default ipaddress
What is the default STP max age value?
A. 20 seconds
B. 30 seconds
C. 40 seconds
D. 60 seconds
An OSPF router type whose interfaces connect to two or more Autonomous Systems is called:
A. BDR
B. ABR
C. Internal Router
D. None of these
In ExtremeWare user account names and VLAN names share the same name space. Therefore a user named efault?cannot be created.
A. TRUE
B. FALSE
What is the maximum specified distance for Extreme LX-100 fiber optic GBIC?
A. 550 meters
B. 10 kilometer
C. 70 kilometer D. 100 kilometer
Which CLI command will list the ports involved in load sharing and also identifies the master logical port?
A. show ports all stat
B. show ports all utilization
C. show ports all configuration
D. All of these
If an asterisk (*) appears in front of the ExtremeWare command-line prompt, what does it indicate?
A. A CLI how?command was executed
B. A CLI ave?command was executed
C. Nothing, because the asterisk is always present anyway
D. None of these
In CSMA/CD, where does CS stand for?
A. Common sense
B. Collision sense
C. Carrier sense
D. Closed subnet
There are two types of the Ethernet protocol, Ethernet2 developed by DIX and 802.3 developed by the IEEE.
A. TRUE
B. FALSE
This CLI command is valid: configure vlan default ipaddress 10.10.1.1/24 255.255.255.0.
A. TRUE
B. FALSE
You are taking steps to secure SNMP access to your switches by turning off SNMP access to the switches. What is the minimum action you need to perform?
A. Enter the CLI Command DISABLE SNMP ACCESS and then reboot the switch.
B. Enter the CLI Command DISABLE SNMP ACCESS
C. Enter the CLI Command DISABLE SNMP
D. Enter the CLI Command DISABLE SNMP and then reboot the switch.
What is the proper CLI command syntax to create a user-level account for johndoe?
A. create user account johndoe
B. create account user johndoe
C. create account johndoe user
D. None of these.
What is the well-known port number for Telnet?
A. 25
B. 110
C. 22
D. 23