599-01 Online Practice Questions and Answers

A customer is looking to deploy Steelhead EX 1160-L's to 10 branches. Each branch is to have a file server with 2TB of storage. What data set size does the Granite Core appliance need to be capable of handling, assuming standard Granite Edge appliance blockstore sizing recommendations? (Each 1160 has been configured with 275 GB/275 GB VSP/Blockstore setting)

A. 20 TB

B. 10 TB

C. 4 TB

D. 2.75 TB

E. 2 TB

Utilizing Granite appliance allows customers to: (Select 2)

A. Remove storage from the branch.

B. Centralize backups.

C. Collaborate on shared files across the whole network.

D. Accelerate centralized file servers.

What is the default write reserve percentage of blockstore size?

A. 5%

B. 10%

C. 25%

D. 30%

What are two optional Windows server plugins utilities for branch offices using Granite appliance?

A. DFS and VSS.

B. VSS and Turbo Boot.

C. IPCFG and Diskshadow.

D. RHSP and Turbo Boot.

E. iSCSI Initiator and iSCSI target.

Granite appliance simplifies backup and restore by migrating these functions to:

A. The data center

B. Tape drives

C. The cloud

D. The branch office

What are the default ports used between the Granite Edge and Granite Core on a Steelhead EX platform?

A. 7150-7154, 7170

B. 7950-7954, 7970

C. Granite uses the same default ports as the Steelhead WAN Optimization

D. 7750-7754, 7770

E. 7050-7050, 7070

Which transmission protocols do Whitewater appliances support? (Select 2)

A. iSCSI

B. NDMP

C. NFS

D. OST

E. SMB/CIFS

What is the maximum ingest rate of the largest Whitewater appliance?

A. Up to 10GB/hr.

B. Up to 500GB/hr.

C. Up to 1.5TB/hr.

D. Up to 2.5TB/hr.

E. Up to 120TB/hr.

Whitewater appliance peer replication is supported in which of the following modes? (Select 2)

A. Single active/single passive (cloud only).

B. Single active/single passive (secondary Whitewater appliance only).

C. Single active/dual passive (cloud and secondary Whitewater appliance).

D. Single active/dual active (cloud and secondary Whitewater appliance in high availability mode).

Which VIF configurations does the Whitewater appliance support? (Select 3)

A. Round robin

B. 801a.d

C. 802.3ad

D. Transmit/receive load balance

E. Transmit load balance

F. Receive load balance

What log will contain information about connection failures to the cloud storage provider?

A. Event log

B. System log

C. User log

D. Server log

If the following system log messages occur during cloud storage provider configuration on Whitewater appliance, select the actions below that can be taken to diagnose the causE. (Select 5)

Riverbed rfsd[29622]: [retry.ERR] (29625) failed request 0 of get_buckets after receiving 1032: "1032:

There was a mismatch between the signature in the request and the signature computed by the server.", status=access denied Riverbed rfsd[29622]: [replicator.ERR] (29625) Failed to list buckets : access denied Riverbed rfsd[29622]:

[rfsd.ERR] (29625) Cloud test faileD. access denied Riverbed rfsd[29622]:

[rfsd.ERR] (29625) Cloud test failed

A. Reboot the Whitewater appliance and see if the error resolves itself.

B. Restart the Whitewater appliance storage optimization service and see if the error resolves itself.

C. Verify the cloud storage provider credentials within Whitewater appliance.

D. Verify the cloud storage provider credentials outside of Whitewater appliance.

E. Take a TCP trace.

F. Check the Whitewater appliance system date/time.

A customer has decided that "application consistency" is a requirement for his Windows application that is currently residing on a LUN's on his NetApp SAN. This LUN, which contains both the operating system and the application in a Windows VMDK have been presented out to a branch. Which of the following data protection strategies would NOT meet the customer's requirement?

A. Host-based backup agents at the branch.

B. Host-based consolidated backups at the branch.

C. Backup from a scheduled LUN snapshot in the data center.

D. Backup from a RHSP LUN snapshot in the data center.

E. Backup of a Granite appliance assisted consolidated LUN snapshot.

Which of the following is an iSCSI-compliant SAN technology with snapshot integration that has been qualified with Granite appliance?

A. EMC VMAX 5876

B. Dell FAS270

C. NetApp FAS270

D. Hitachi PS4000

E. IBM XIV 3000

What feature should be used to increase the performance of a Windows server booting on a Granite appliance LUN that is not pinned and prepopulated? (Select 3)

A. RHSP Riverbed Hardware Server Process.

B. Steelhead Granite Application Acceleration.

C. Riverbed Turbo Boot.

D. High Speed TCP Options for Granite.

E. Local LUN on Granite Edge.