Cisco 300-615 dumps - 100% Pass Guarantee!

Refer to the exhibit.

An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?

A. Adjust the MTU on Router-A to 1600.

B. Disable the check of the MTU value.

C. Set the OSPF media type to point-to-point.

D. Adjust the MTU on Router-B to 1604.

Refer to the exhibit.

VSAN traffic is not routed as expected. Which action should be taken to resolve the issue?

A. Reset the error packet counter

B. Configure the hello timer to match the neighbor

C. Configure the FSPF dead interval with a value higher than 80 seconds

D. Reset the inactivity timer on switch-2

Refer to the exhibit.

A functioning trunk port Ethernet1/48 exists between two identical Cisco Nexus 5000 Series Switches. The interfaces on the switches support the MACsec feature and are configured identically. The trunk port stops functioning. Which action should be taken to resolve the issue?

A. Disable and then enable the port

B. Enable the license for the trunk ports to support MACsec

C. Lower the MTU value to less than 9216 bytes

D. Configure the PMK with a length of 2048 bytes

A client reports that many flaps and server cluster disconnects are occurring in its data center. While troubleshooting the issue, an engineer discovers that a network attack is hitting the Cisco Nexus 7000 Series Switches and that the source IP addresses are spoofed. Which first-line security solution resolves this issue?

A. Dynamic ARP Inspection

B. Unicast RPF

C. IP Source Guard

D. Storm Control

Refer to the exhibit.

The vPC neighborship between two switches is in suspended state. Which configuration change resolves the issue and brings up the vPC neighborship?

A. Change STP Port Type to Network on the peer switch

B. Enable Bridge Assurance on the local switches

C. Configure QoS MTU value of 9216 on the peer switch

D. Add VLAN 400-401 to the configuration on the local switch