Oracle 1Z0-100 dumps - 100% Pass Guarantee!

Examine these statements and their output taken right after successful install of Oracle Linux:

[root@FAROUT /] rpm q firstboot Firstboot -1.110.10-1.0.2.e16.x86_64

[root @FAROUT /] # chkconfig - - list firstboot Firstboot 0:off 2:off 3:off 4:off 5:off 6;off

[root@FAROUT /] # /etc/sysconfig/firstboot RUN_FIRSTBOOT=NO

What is the conclusion?

A. The option to run firstboot was deselected during Oracle Linux installation.

B. The system was installed with desktop graphical packages and rebooted and the firstboot utility ran successful.

C. Firstboot never ran in any run level because the service is turned off for all run levels.

D. The system was installed without selecting desktop graphical packages, thereby disabling firstboot from running.

Which two conditions should be met in order to successfully configure an openssh client on Oracle Linux?

A. The openssh-server package must not be installed.

B. The openssh package must be installed.

C. The sshd daemon must not be started.

D. The openssh-client package must be installed.

E. The ssh-agent must be started.

F. ssh keys must be generated by any user using the ssh client.

Examine the output of a bonded interface configuration from which one network cable has been unplugged:

# cat /proc.net/bonding/bond0 Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth2 MII Status: up MII poling interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth1 MII status: down Link Failure Count: 1 Permanent HW addr: 00:0c:29:7b:3c:71 Slave Queue ID: 0 Slave Interface: eth2 MII Status: up Link Failure Count: 0 Permanent HW addr: 00:0c:29:7b:3s:7b

Which statement is true when you plug in the eth1 network cable?

A. The status of the slave interface eth1 changes to up and is promoted to the active slave and eth2 becomes the backup slave.

B. The status of the slave interface eth1 changes to up and becomes a second active slave.

C. The status of the slave interface eth1 changes to up but must be manually assigned the active or backup slave role.

D. The status of the slave interface eth1 changes to up and becomes the backup slave.

Examine some of the contents of the /boot/grub/grub.com file from an Oracle Linux system:

Default=0 Timeout=5 Splashimage=(hd0, 0)/grub/splash.xpm.gz Hiddenmenu Title Oracle Linux Server (2.6.39-100.0.12.16uek.x86_64)

Root (hd0, 0)

Kernet /vmlinuz-2.6.39-100.0.12.e16uek.x86_64 ro root=UUIP=a4b6049b-9aa1-44b4-87cfaebb17alcdf9 rd_NO_LUKS re_NO_LVM rd_NO_DM LANG=en_US.UTF-8 SYSFONT=1atarcycreheb-sun16 KEYBOARDTYPE=PC KEYTABLE=us rhgb quiet numa=off Initrd /initramfs-2.6.39-100.0.12.e16uek.x86_64.img Title Oracle Linux Server (2.6.32-131.0.15.e16.x86_64)

Root (hd0, 0)

Kernel /vmlinuz-2.6.32-131.0.15.e16.x86_64 ro root=UUIS=a4b6049b-9aa1-44b4-87cf-aebb17a1cdf9 rd_NO_LUKS rd_NO_LVM rd_NO_LVM re_NO_MD rd_NO_DM LANG=en_UD.UTF-8 SYSFONT=latarcyheb-sun16 KEYBOARDTYPE=PC KEYTABLE=us Crashkernel=auto rhgp quiet numa = off

Initrd /initramfs-2.6.32-131.0.15.e16.x86_64.img

Which three statements are true about the behavior and configuration of GRUB on this system?

A. (hd0, 0) represents the first partition on device /dev/hd0.

B. The hiddenmenu directive hides the GRUB menu only for 5 seconds after which it becomes visible again.

C. The root directive specifies an initial root filesystem, allowing access to block device modules to mount the real root filesystem on disk.

D. (hd0, 0) represents the first partition on the first drive detected by the BIOS.

E. The initrd directive specifies the initamfs, an initial root filesystem in RAM, allowing access to block device modules to mount the real root filesystem.

F. Each kernel must have an initramfs that matches the version of the kernel.

G. Because there is an Unbreakable Enterprise Kernel installed, it must be the default kernel listed as shown by the default=0 directive.

Which two statements are true about the Ksplice patching feature feature of Oracle Linux when running in standard mode? (Choose two.)

A. It can update both the Unbreakable Enterprise Kernel (UEK) as well as the Red Hat compatible kernel

B. It can update both the running kernel in memory and the corresponding kernel image on disk

C. It requires access to the Internet, either direct or via a proxy server

D. It can update the kernel without rebooting the system

E. Updates to the Ksplice software are installed automatically