Where should sx_api_ports_dump.py command be ran?

A. Management server

B. Security Group

C. Orchestrator

D. SMO Appliance

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two Orchestrators?

A. Port 1 in Slot 2 and Port 2 in Slot 1

B. This configuration is not supported

C. Any pair of available ports

D. Port 1 in Slot 1 and Port 2 in Slot 1

The core four manual diagnostic tools include:

asg diag verify, asg perf -v, orch_stat -all, and

A. asg diag verify

B. cpinfo

C. hcp -r all

D. asg stat -v

During an upgrade, Is Multi-Version Clustering (MVC) supported?

A. No. Maestro does not support MVC because ClusterXL is disabled during an upgrade.

B. No, Maestro does not support MVC.

C. Maestro supports MVC or full connectivity upgrade as of R80.40.

D. Yes, MVC is supported as of R81 for Maestro.

Which command do you use to find bottlenecks in the system that are affecting performance, even functionality in some cases?

A. asg stat -v

B. asg diag verify

C. asg perf -v

D. asg monitor

What is the maximum number of Appliances within the same Security Group?

A. 31

B. 8

C. 52

D. 16

Do all MHOs need to be upgraded before starting the SGM upgrades?

A. During the upgrade process all SGMs should be upgraded before upgrading all of the MHOs.

B. A minimum of one of the MHOs should be upgraded before starting the SGM upgrades.However, there is no requirement to upgrade all the SGMs during the same maintenance window as the MHO

C. All MHOs must first be upgraded before starting the SGM upgrades However, there is no requirement to upgrade all the SGMs during the same maintenance window as the MHOs.

D. MHOs do not need to be upgraded at all because Maestro supports the use of different versions between the MHOs and SGMs.

Maestro allows running commands globally in Expert mode by using global prefixes, such as:

A. asg all

B. g_all

C. all

D. global

What does asg monitor command do?

A. This command does not exist

B. Monitor health status of entire system

C. Monitor traffic on Appliances in Security Group

D. Show real-time cluster status of Appliances in Security Group

What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

A. Two Out-of-band interfaces for access to Orchestrator itself

B. 1Gbps connectivity for Security Groups

C. Out-of-band interface for access to Orchestrator itself and Serial Console connector

D. Reserved for internal purposes. Not in use

Which blade configuration files should be backed up on the SG if upgrading from R80.30SP or earlier?

A. IPS configuration files

B. fwkern.conf files.

C. VPN configuration files

D. Mobile Access configuration files.

What is the maximum number of Appliances within Security group in Dual-Site configuration?

A. 28

B. 31

C. 15

D. 16

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

A. 100%/0%

B. 33%/66%

C. 50%/50%

D. 66%/33%

What is one benefit of a Dual MHO environment?

A. Dual MHOs provide redundancy to the Maestro environment by increasing throughput by at least 50 percent.

B. Dual MHOs allow better synchronization to occur between SGMs.

C. Dual MHOs allow additional SGMs to be added to the SG.

D. Dual MHOs can be used to achieve increased scalability and redundancy.

What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI

A. Remote orchestrator has no empty interfaces

B. Single orchestrator environment, but configured Orchestrator amount is 2

C. One orchestrator only, but Orchestrator amount is 2 or no Sync in between orchestrators

D. No Sync between orchestrators